Mini

Tesla Coil

Secondary Coil


Here is my secondary coil. Made from a 2.375" diameter 14.5" long section of PVC pipe.
The pipe was baked in an oven and sealed with polyurethane. It is wound 12.75" long with 28AWG
enameled wire.

These pictures are in 640x480 pixles resolution for a higher resolution click on the pic.



This is a picture of the finished secondary coated many times with polyurethane and end caps in.


Here is the end cap its made from three pieces of plexi glass, one is solid the other two
have been drilled for nuts so that it may be screwed down to the secondary and screw on the toroid,
all pieces were glued together and glued in place.



email me at moonol05@email.pct.edu
if you have any question or any tips.
last updated 09/28/02

Back To Terry's Web Site